FAQ's


How does the SnowSport™ Install on my vehicle?
 
The SnowSport™ personal utility plow hooks up to the front receiver (2" square tube) hitch, just like hooking up a receiver on a hitch used at the rear of a vehicle for towing trailers. You may also attach it to the rear of the truck, using the plow in reverse.

Is a front receiver hitch needed?

No! the Snow Sport Snow Plow will work quite well using your existing rear receiver hitch. However many choose to use a front mount, and it comes optional with the plow package along with instructions to install it.

How difficult is it to install the hitch and plow?

The front end hitches are designed to bolt in place on most models - occasionally, certain models may require drilling. The instructions are clear cut. The front receiver hitch is mounted to the vehicle and the push frame is plugged into the front receiver hitch. The plow simply hangs on the push frame.

Can I install the SnowSport™ Plow myself?

YES, the instructions are clear cut. If you do need assistance, call 1-800-233-4655 between 9-5pm CST. Our customers overwhelmingly say "it was simple and easy to install".
The front hitch varies from vehicle to vehicle. Plan on about 30 minutes to 1 hour depending on your level of experience. The plow is attached in minutes by plugging in the push frame and attaching the plow to it.

How is the SnowSport™ Plow shipped?

It is shipped via common carrier in three seperate boxes. The plow box, push frame box and optional receiver hitch box, if you ordered it.

How easy is the SnowSport™ Plow to hook up or un-hook between jobs?

It's very easy. Just insert the push frame into the front receiver hitch and secure with pin. Then hang the blade one end at a time onto the push frame (can be done in less than a minute). Unhooking is just as easy.

How do you switch from transporting to plowing or from plowing to transporting?

The operator must manually unhook the plow and lower it for plowing. For transporting simply lift the blade, one side at a time, onto the push frame.

How can the SnowSport™ Plow operate without hydraulics?

The blade is secured by the push frame. As you push the snow, the blade travels up and down as needed by gravity. The rubber cutting edge is designed to cut through the snow but pass over the harder ground surfaces below and be gentle on grass. Then, when you back up, the blade automatically lays back, skimming over the surface. Then you drive forward and the blade re-engages for plowing.

How well does the rubber cutting edge and box ends hold up?

The rubber cutting edge is 1" thick 6" high - made of a hard rubber compound. This has been tested and proven to provide years of service. It can be replaced relatively inexpensively.

What is the warranty?

The plow has a 1-year limited warranty. See your owners' manual for details.

Can I move the SnowSport from one vehicle to another?

Yes, the plow can be easily transferred to another vehicle, all you need is a receiver hitch on either the front or the rear.

Is the SnowSport™ available for my vehicle?

It is available for most late model pickups and SUV's. Go to the snow plow page for a listing of vehicles it is available for.

How much does the snow plow weigh?

The aluminum blade is about 110 lbs. The complete kit with blade, push frame, and hitch is about 225 lbs.

What is the ' Optional Angling Interceptor'?

• Allows you to angle your SnowSport Snow Plow in seconds
• Works with all SnowSport snow plow kits
• A simple upgrade to install on your snow plow
• Replaces the standard interceptor that comes with SnowSport Snowplow Kit
  
   
   

Back to Snow Sport Snow Plows