|
Truck bed
surface temperature should be at least 68°F for proper installation.
Warning: Improper installation will result in liner flying out of
truck!
Follow instructions exactly!!
|
1.
2.
3.
4.
5.
|
Read all instructions before installing.
The floor and siderugs are shipped unzipped.
Remove floor and siderugs from box.
Zip floor and siderugs together to form the one-piece soft bed liner.
A very aggressive hook and loop fastening system has been designed to hold
the bedliner
in open bed trucks. |
|
6.
|
A continuous
loop fastener is sewn around the liner. The bulkhead and tailgate have two
continuous strips of loop fastener sewn along the top and bottom. The hook
fasteners have a self-adhesive backing to stick to the bed of the truck. |
 |
|
7.
|
Lay the Bedrug
soft bed liner in the bed of the truck to determine the exact location and
fit.
Note: Some truck beds are equipped with tie-down hooks, load extenders and
other functional equipment. These may be located on the floor, bulkhead or
sidewalls. For equipment such as this, the installer must either:
|
| |
A. |
Cut a small
slit in the appropriate area of the Bedrug allowing the equipment to
protrude through the Bedrug into the truck bed. (This will not damage the
Bedrug.) or
|
| |
B.
|
Remove the equipment until the installation is complete, then reinstall the
equipment on top of the Bedrug.IMPORTANT: Never cut or put slits through any
seams or sewn areas of the Bedrug. This will cause the seam to come
completely apart.Refer to illustration for completing steps 8 -14. Roll one
side of the Bedrug up exposing the floor area where the 3" strip of hook
fastener is to be adhered. |
|
8. |
Roll one side of the Bedrug up, exposing the floor area, where the 3" strip
of hook fastener is to be adherred. |
|
9. |
Using a clean lint-free cloth, clean this area thoroughly using
NON-PETROLEUM based solvent. Then with a separate cloth, clean the same area
again with alcohol. If the cloths become visually soiled, replace them with
clean ones. |
|
10. |
Attach hook fasteners to the loop. For siderugs, be sure to place the 2"
long hook fasteners at the locator marks which are molded into the foam.
Remove the protective liners for the hook fasteners exposing the adhesive.
(See Illustration) Lay the Bedrug down, then FIRMLY rub the fastener(s) down
VERY AGGRESSIVELY to assure full engagement of the fastener(s) and the
adhesive.
Note: Truck bed surface temperature should be 68°F or higher in order for
the hook fastener to achieve maximum adhesion. Also, never contaminate the
adhesive by touching it with your fingers. |
|
11. |
Repeat steps 9 and 10 for the opposite side of the Bedrug. |
|
12. |
Repeat steps 9 and 10 on the bulkhead. |
|
13. |
Repeat steps 9 and 10 on the siderugs. |
|
14.
|
Repeat Steps 9
and 10 on the tailgate.
|
